|
|
#1
07-19-2010, 08:33 PM
|
|||
|
|||
430 piston
I'm after a 430-11631-01-96/97 piston so i can get a cylinder replated, even if only on a loan basis just so i can get the replating done with langcourt in england, please as these buggers are so hard to find, the last 2 cost me $220.00 each, not used much but would prefer a new piston for replating puposes, please if anyone can help.
Thank you Bill. 
|
|
#2
07-20-2010, 02:21 PM
|
||||
|
||||
|
There is one on its way!
 Take good care of it! 
|
|
#3
07-20-2010, 09:24 PM
|
||||
|
||||
|
.
Aaah, beat me to it! If there are any probs Billy let me know. I have a couple here. Greg
__________________
Check out the 350 page book I wrote a few years back covering every Yamaha TD,TR,TA and TZ made between 1959 and 1982 by clicking here: http://www.tz350.net/yamaha_two_stro...orcycle s.htm NOTE: It is now only available via eBay auction!
|
|
#6
07-22-2010, 08:58 PM
|
|||
|
|||
|
Lech pistons for these things come in 3 sizes if your lucky enough to find them, 56.96, 56.97 and 56.98, so the need to supply a piston + clearance.
P.S don't put Chrome rings in a chrome bore, funny after all these years of using the correct rings i got it wrong, must be the Old age memory loss.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
